Effacer les filtres
Effacer les filtres

Fuzzy control problem:(1)no rules fired for Output 1(2)input 1 expects a value in range [-1 1], but has a value of 700.

68 vues (au cours des 30 derniers jours)
In 'UPQC_fuzzy_1/FuzPID/Fuzzy/Fuzzy Logic Controller', input 1 expects a value in range [-1 1], but has a value of 700. [341 similar]
Component:Simulink | Category:Block warning
In 'UPQC_fuzzy_1/FuzPID/Fuzzy/Fuzzy Logic Controller', no rules fired for Output 1. Defuzzified output value set to its mean range value 0.[723 similar]
Component:Simulink | Category:Block warning
The specified buffer for 'UPQC_fuzzy_1/PLL/Model/Automatic Gain Control/Positive-Sequence (PLL-Driven)/Mean (Variable Frequency)1/Model/Variable Transport Delay' was too small. During simulation, the buffer size was temporarily increased to 22528. In order to generate code, you need to update the buffer size parameter [3 similar]
Component:Simulink | Category:Block warning
BTW,the simulation is very slow, maybe it's related to the masses of warnings.
Can anyone help me? Thank you so much !
E mail: 213162941@seu.edu.cn
  7 commentaires
Poonam
Poonam le 2 Avr 2024
I have same problem of size and no rules fired for output
Sam Chak
Sam Chak le 2 Avr 2024
@Poonam, To better understand and address the "No rules fired" issue in your fuzzy system, you are advised to open a new question and provide the complete details of your fuzzy system.
This will allow us to examine the membership functions involved and identify the potential cause of the problem.

Connectez-vous pour commenter.

Réponses (0)

Catégories

En savoir plus sur Fuzzy Logic in Simulink dans Help Center et File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by