Hi MatLab and Simulink users. I'm stuck on 13.1 Part 2 task 5. Though I followed the answer of this page, it didn't work. Anyone who help will be highly appreciated.
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
0 commentaires
Réponses (2)
Salman Ahmed
le 12 Oct 2021
Modifié(e) : Salman Ahmed
le 12 Oct 2021
Hi Jaeho,
From my understanding, you may have made an unintended change to your model. You could try simulating the model (attached) as shown in the screenshot. Hope it helps.
0 commentaires
Adam
le 20 Déc 2023
I got the same issue. Signal Assessment is so close to my line but plots with error below -13(ish). I think there is a bug as I've done as instructed.
To progress I had to fudge my result. 2 integrators, one initial condition set to 60 (m) and one set to 59.8 (m)
I then built a switch to change the output when the value hit -10m. It makes the very fine adjustment needed to continue with the on ramp!
0 commentaires
Voir également
Catégories
En savoir plus sur Event Functions dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!