Parfor does not parallelize after the first time
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am using 16 workers.
My parfor loop requires 70 loops in total.
When I run the parfor it starts 16 loops.
Then as the loops finish one by one, the solver does not start new loops.
It accepts one loop at a time for the rest of load.
So the parallelization stops after the first time the load is distributed.
How can I overcome this problem? Thank you.
2 commentaires
Abdolkarim Mohammadi
le 22 Mai 2020
Please provide your code or at least its outlines. parfor uses several techniques to figure out how to chop your matrices for parallel computationn, so it should be used carefully. Using for instead of parfor can be useful for debugging since debugging cannot be done inside a parfor loop.
Réponses (0)
Voir également
Catégories
En savoir plus sur Parallel for-Loops (parfor) dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!