
Error: "Each physical network must be connected to exactly one Solver Configuration block. There is no Solver Configuration block connected to Physical Network with the following blocks..."
62 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I would like to Implement the following (see image on the left) Pulse Width Modulation (PWM) circuit on Simulink (see image on the right). However, i keep getting the following error:
"Each physical network must be connected to exactly one Solver Configuration block. There is no Solver Configuration block connected to Physical Network with the following blocks..."
Could someone help me out? Thanks!

0 commentaires
Réponses (2)
Dr. Pemendra Kumar Pardhi
le 4 Nov 2020
Dear,
You have to recuired Solver Configuration block at grounding point as shown in attached file

the Solver Configuration Block can be obtained from
Simulink Library> simscape>foundation library> utilies
3 commentaires
Joel Van Sickel
le 4 Nov 2020
Hello,
the solver configuration block is a simscape block under utilities that you can connect to any part of your simscape network. It associates local solver settings for that simscape network since simscape uses more complex solver's than simulink does. You should be able to start with the default settings.
Regards,
Joel
0 commentaires
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur Nonlinear Operators dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!