How can I use the simplfied synchronous generator in SimPowersystems in a phasor simulation type?
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am attempting to use a simplified synchronous generator from the Simpowersystems lab in modeling a distribution system for my Smartgrid class. I want to sue this generator as the power source becacause it will allow the sutdents to develop a control system for its output voltage. Ultimately we wouild like to model the behavior of the system over a 24 hour period and incorporate changing loads and renewable energy sources. Unless I can run in phsor mode, the simulation time and memory required will be prohibitive. When I add the generator to the distribution network and run in continuous mode over a short period (10 seconds) I get the expected voltages in the circuit. When I run the simulation in phasor mode, I get absurd values, like 3e108. what is going on with this model block and how do I correct it? Are their example models that use this block in phasor mode that I can look at?
0 commentaires
Réponses (1)
Joel Van Sickel
le 11 Déc 2020
power_simplealt can be switched to phasor mode, there will be a small perturbance at start, but then it works.
0 commentaires
Voir également
Catégories
En savoir plus sur Electrical Sensors dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!