Error "Derived parameter initialization for Vbe_sat failed to converge"
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Ander Erroicenea
le 22 Déc 2020
Réponse apportée : Joel Van Sickel
le 22 Déc 2020
Hi there,
I'm trying to model an IGBT using the N-Channel IGBT block (simscape electrical library), but I obtained the above mentioned error. From what I've observed it seems that the error is related to the value that I introduced in the "Collector current at which VCE(sat) is defined" parameter where I put 1.000A (same value as in the datasheet).
I'm using the Full I-V and capacitance characteristics variant and concretely equivalent circuit based on a PNP bipolar transistor and N-channel MOSFET mode.
These are the values that I've introduced in the main tab:
Ices: 10mA
Voltage at which Ices is defined: 1700V
Vge(th): 6.5V
Vce(sat): 2.15V
Collector current at which Vce(sat) is defined: 1000A
Gate-emitter voltage at which Vce(sat) is defined: 15V
Temperature: 150
Is there someone who knows how to solve the error?
Thank you in advance,
Ander.
0 commentaires
Réponse acceptée
Joel Van Sickel
le 22 Déc 2020
Hello Ander,
the issue is that RC and RE need to be lower to calculate a realistic Vbe-sat. I believe it needs to be lower than Vce. To do this, lower the values in the advanced tap of RC and RE. I tried lowering them both by a factor of 100 and was able to get it to work.
Regards,
Joel
0 commentaires
Plus de réponses (0)
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!