Is there support for National Instruments NI 9220 in Data Acquisition Toolbox earlier than 3.3 ?
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am looking at using a NI 9220 analog input module inside a cDAQ-9181 chassis and acquiring data with MATLAB. The hardware support table says that the NI 9220 requires Data Acquisition Toolbox version 3.3 but in the release notes for 3.3 there is no mention of adding this support, other than saying there is support for clocked digital I/O. I'm not doing digital I/O, just analog ADC, so would the NI 9220 be supported in earlier versions? Especially R2012a (3.1). The chassis gained support in 3.1.
0 commentaires
Réponses (1)
Nichole Heydenburg
le 20 Oct 2020
Hi,
There does not seem to be anything specific in the update lists. However, since it does say that the NI-9220 requires Data Acquisition Toolbox version 3.3, then I would be willing to bet it can not take an older version. If that is the case, then it would probably say something like "version 3.1 or later."
0 commentaires
Voir également
Catégories
En savoir plus sur National Instruments Frame Grabbers dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!