How to get the desired frequency in simplified synchronous machine?
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello,
when i simulate the model using simplified synchronous machine the output frequency is not proper. The parameters which i am supposed to use to get a frequency of 400Hz is N=6000(the input to the model is 628rad/s), pole pairs=4. when i give this parameter i don't get a freq of 400Hz, why is this? is there any other parameters that i have to change? if so please help me.
8 commentaires
syed zia
le 23 Mai 2013
I also need da same thing ,want to measure the frequency...and its variation after increasing load.........plz help me tnx....
Réponse acceptée
John Doe
le 6 Mai 2013
Modifié(e) : John Doe
le 6 Mai 2013
The electrical frequency is, as stated in the comments:
f_elec = poles * f_mec / 2
I was wondering what you were doing, because I can't see where you get in trouble. In a synchronous machine, the output frequency is only a function of the number of poles, and the rotor frequency, nothing else.
Since I don't know how you achieved 0.153Hz, I asked to see your model, so that I could try to figure out where your error is.
Thus, the answer to your question: "Is there any other parameters that i have to change?" is No, nothing else must be changed.
Best of luck!
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Switches and Breakers dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!