How to change terminal PFI of DAQ channel?

4 vues (au cours des 30 derniers jours)

Hyeokjin Jho le 2 Avr 2021

Modifié(e) : Hyeokjin Jho le 2 Avr 2021

I am using NI 6052E. I have to count input pulse using counter ctr0. The input signal is physically connected to PFI0.

However, if I create channel using addinput, it forces input terminal to be default value, PFI8. Is there any way to change this input terminal?

Currently, when I run this code,

daqobj = daq('ni');
counterChannel= addinput (daqobj,'Dev1','ctr0','Edgecount');
disp(counterChannel.Terminal)

it gives

'PFI8'

En savoir plus sur Data Acquisition Toolbox Supported Hardware dans Help Center et File Exchange

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by