FFT results correct for following filtering?
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
EmirBeg
le 4 Mai 2021
Réponse apportée : Star Strider
le 4 Mai 2021
I have inductive measurement data that i want to filter with a lowpass, so first i want to get the frequency spectrum to know what to filter out.
I used the following code to do the FFT motivated by an answer to a question i was reading here.
%% FFT
load('CH0.mat');
load('t.mat');
L = numel(CH0);
Ts = mean(diff(t));
Fs = 1/Ts;
Fn = Fs/2;
CH0FT = fft(CH0-mean(CH0),[],1)/L;
Fv = linspace(0, 1, fix(L/2)+1)*Fn;
Iv = 1:numel(Fv);
CH0abs = abs(CH0FT);
plot(Fv,mag2db(CH0abs(Iv)*2));
As you see it look like this:
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/606690/image.jpeg)
Usually i would expect a peak at a certain frequency so i could filter the other frequencys out but here is just a big peak near zero and also the frequencys are smaller than i would expect.
Do you see any mistakes or is it just the way my sensor measures? How would you filter it? I also attached the data. Thank you!
0 commentaires
Réponse acceptée
Star Strider
le 4 Mai 2021
That signal and ‘CH0’ here are apparently quite noisy with a large low-frequency component. Consider using a lowpass filter if you only want to isolate the low-frequency component (likely 0 to 0.001 frequency units here).
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Multirate Signal Processing dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!