Carmaker for simulink mex file not unloaded from memory

I am using Matlab 2020b and Carmaker 10. When I run(simulate) Carmaker for Simulink model (even the generic model) for the first time (after a full Matlab restart), it runs fine and I can stop the simulation. But when I run (by either pressing Simulate on Simulink or Start on Carmaker GUI) it again, I get this error. I have tried munlock, clc, clear. But nothing seems to work and I have to restart matlab entirely as suggested by the error. This error seems to suggest for some reason, the libcarmaker4sl.mexw64 was not unloaded from Matlab in the previous run. Any ideas why this might be happening? (I repeated the same experiment with 2019a and CM 9.1 with same results).

[Carsten Lenz]

Hello,

did you find a solution for that?

I currently have the exact same problem. Maybe I am lucky and you already found something.

Best regards

[Omkar Karve]

No!! I have been struggling with this for over a year. I have an open ticket with both Mathworks and IPG.

https://forums.ipg-automotive.com/t/cm4sl-project-unable-to-unload-mex-file-after-simulation/222

[Andreas]

Same here.

Did you find any solution?

[Omkar Karve]

Unfortunately no. No one knows why this is happening.