I am getting an error in running the following model

I tried building a motor controller using simulink and tried running but got the error as shown in figure below

Answer 1

[Akshat Dalal]

Hi Varun,

This error mostly occurs due to an unrealised divide by zero in the modelling logic. You can try the following steps to debug this further:

In the Configuration Parameters, set the diagnostic "Inf or NaN block output" to 'error', adter which you will get the following erro if you have an Inf or NaN:

An error occurred while running the simulation and the simulation was terminated

It will also list the block which is causing the error.