How can I use Matlab command line to open/close signal viewer interfaces in Simulink 7.8 (R2011b)?
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
MathWorks Support Team
le 12 Déc 2011
Commenté : Cory Dinkle
le 20 Déc 2021
I have a signal viewer attached to a signal line in my Simulink model. I want to open and close this signal viewer through MATLAB command line interface. I do not want to interact with the Simulink interface by double clicking on its symbol on the model. I have subsystems in my model and the signal viewer could be attached to any level in the model.
Réponse acceptée
MathWorks Support Team
le 12 Déc 2011
Consider the model 'testMdl.mdl'. There is a viewer named "MyViewer" in the top layer of the model and there is another viewer named 'ViewerInSubsystem' inside the subsystem. I can open and close these viewers from MATLAB command line using the following code:
>> mdl = 'testMdl';
>> open_system(mdl);
>> set_param( [mdl '/MyViewer'],'open','on');
>> set_param( [mdl '/ViewerInSubsystem'],'open','on');
>> set_param( [mdl '/MyViewer'],'open','off');
>> set_param( [mdl '/ViewerInSubsystem'],'open','off');
However deep the signal viewer is in the model, they can always be accessed programmatically by specifying the model name and the signal viewer name. It is not necessary to point to the location where the viewer exists in the model.
1 commentaire
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Programmatic Model Editing dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!