ghulam murtaza

Last seen: 2 mois il y a | Actif depuis 2019

Followers: 0 Following: 0

Message

Statistiques

Afficher les badges

Feeds

Réponse apportée
Repeating sequence Error ?
Use Scope of Simulink> Commonly used block , not use time scope for display

plus de 5 ans il y a | 0

Question

How can i get the exact frequency of generated waveform on stm32f407. When I use case A , burn it on stm , i get exact frequency 1kHz(Same as that of input pulse) . But when i burn both Cases A and B the frequency gets reduced to 800Hz .

plus de 5 ans il y a | 1 réponse | 0

0

réponse

Question

Hw can I controll rise and fall edge of a pulse according to my own requirement for particular time and then applying required pattern on that holdon interval > As given below

plus de 5 ans il y a | 1 réponse | 0

0

réponse

Question

How can i display the analog signal from stm32f4xx to the scope of matlab simulink
Sir, I'm using stm32f401 controller , i want to display the sine wave (with DC offset) of signal generatore in the matlab scop...

plus de 5 ans il y a | 1 réponse | 0

0

réponse