Statistiques
RANG
263 331
of 300 788
RÉPUTATION
0
CONTRIBUTIONS
6 Questions
2 Réponses
ACCEPTATION DE VOS RÉPONSES
66.67%
VOTES REÇUS
0
RANG
of 21 091
RÉPUTATION
N/A
CLASSEMENT MOYEN
0.00
CONTRIBUTIONS
0 Fichier
TÉLÉCHARGEMENTS
0
ALL TIME TÉLÉCHARGEMENTS
0
RANG
of 171 083
CONTRIBUTIONS
0 Problèmes
0 Solutions
SCORE
0
NOMBRE DE BADGES
0
CONTRIBUTIONS
0 Publications
CONTRIBUTIONS
0 Public Chaîne
CLASSEMENT MOYEN
CONTRIBUTIONS
0 Point fort
NOMBRE MOYEN DE LIKES
Feeds
Question
Problems getting Master Transfer Block to function
I would welcome a pointer to some clearer documentation for the c28x SPI Master Transfer block in provided for TI MCU for use in...
environ 3 ans il y a | 1 réponse | 0
1
réponseQuestion
SPI interface timing with deasserts
I'm looking for a way to read data from a Si8380S-IU chip from a TI F2337xD based processor. The Simulink examples for Master T...
environ 3 ans il y a | 1 réponse | 0
0
réponseQuestion
Problem with external mode and model running on target hardware
When attempting to connect a model running on the target hardware I encounter "External mode simulation is not supported for mod...
plus de 3 ans il y a | 1 réponse | 0
1
réponseHow to concatenate array of signal values in a for loop block in simulink with himself Indefinite number of times
Had the same issue, resorted to the following, which is not much use for a larger number of values, but it did mean I could add ...
plus de 3 ans il y a | 0
Question
Errors when examining CAN log output in Mathworks
I'm getting an error "Reference to non-existent field 'x_440V_Tripped' when attempting to load a CAN log file from a simulation ...
plus de 3 ans il y a | 1 réponse | 0
1
réponseQuestion
Ordering of CAN signal ports, when CAN Pack/Unpack is using "CANdb specified signals"
Regardless of the order in the CANdb file or the bit order assigned to signals, CAN unpack will show its outputs in alphabetical...
plus de 3 ans il y a | 1 réponse | 0
1
réponseUnclear error message for Swicth-Case Action on model update
Loss of access to the reference sub system location caused all the connections to become 'disconnected' even though the lines re...
plus de 3 ans il y a | 0
| A accepté
Question
Unclear error message for Swicth-Case Action on model update
The error message "The action port on subsystem '......../Chip1_WriteBytes1' can only be connected to an If or Switch-Case and m...
plus de 3 ans il y a | 1 réponse | 0
