Shengnan Li
Franklin Electric
Followers: 0 Following: 0
Statistiques
RANG
175 245
of 290 019
RÉPUTATION
0
CONTRIBUTIONS
7 Questions
1 Réponse
ACCEPTATION DE VOS RÉPONSES
28.57%
VOTES REÇUS
0
RANG
of 19 621
RÉPUTATION
N/A
CLASSEMENT MOYEN
0.00
CONTRIBUTIONS
0 Fichier
TÉLÉCHARGEMENTS
0
ALL TIME TÉLÉCHARGEMENTS
0
RANG
of 144 418
CONTRIBUTIONS
0 Problèmes
0 Solutions
SCORE
0
NOMBRE DE BADGES
0
CONTRIBUTIONS
0 Publications
CONTRIBUTIONS
0 Public Chaîne
CLASSEMENT MOYEN
CONTRIBUTIONS
0 Point fort
NOMBRE MOYEN DE LIKES
Feeds
Question
Can someone provide a peak current mode controlled buck or boost circuit model in simulink?
Does anyone have a peak current mode controlled buck or boost or other power circuit model?Save me some time. Thanks a lot.
presque 3 ans il y a | 1 réponse | 0
0
réponseQuestion
how to control Ball valve input signal s
The ball valve model has an input signal s to control ball displacement. I don't understand how it is controlled. for example, i...
plus de 7 ans il y a | 1 réponse | 0
1
réponseQuestion
signal input of orifice/valve
How to specify this input? Thanks,
plus de 7 ans il y a | 1 réponse | 0
0
réponseQuestion
Why signal changes rise/fall time outside the subsystem block?
I have a subsystem that has a direct look up table in it. the output of this look up table is the upper one in the attached fig....
presque 8 ans il y a | 1 réponse | 0
0
réponse'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...
presque 8 ans il y a | 0
| A accepté
Question
'to workspace' data length question
I specified the sample time for 'to workspace' block to be 10^(-5), but it saved only 20k data points, while it should be 100k d...
presque 8 ans il y a | 2 réponses | 0
2
réponsesQuestion
how to get the average frequency for the hysteresis band control?
I am simulating a Direct torque control induction motor. Want to know the average frequency. How do i get it from the switching...
presque 8 ans il y a | 1 réponse | 0
1
réponseQuestion
Why I get different data from 'to workspace' and 'scope'
I have a switching signal, and a 'edge detector', try to count the pulses. The results from scope looks very good, the 'edge det...
presque 8 ans il y a | 1 réponse | 0