How to implement Hermite spline in Simulink
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
MARCO LORENZI
le 22 Sep 2021
Modifié(e) : MARCO LORENZI
le 24 Sep 2021
Good morning everyone.
Can i ask if it there is a way to implement the Hermite spline (pchip) or Bezier curves in simulink?
In particular, i am using a look-up table to interpolate a curve between some point, but the cubic and akima splines don't do a good job. I was thinking about using a linear interpolating method and then smoothen up the curves, but i can't find any blockset.
Thank you very much in advance.
0 commentaires
Réponse acceptée
Bjorn Gustavsson
le 22 Sep 2021
There is a way to make blocks that wrap a matlab-function (matlab-functions-simulink_5), shouldn't that solve this task?
HTH
5 commentaires
Bjorn Gustavsson
le 24 Sep 2021
To me it seems as you swapped the x and xq in the function. It ought to be:
function output = low_angles_Hermite_approximation(phase)
xq = phase;
y = [0 0 0 0 0 0 0 1 1];
x = [0 2.5 5 7.5 10 13 15 30 90];
output = pchip(x,y,xq);
When you program and run into errors like these read the help and documentation carefully - and calmly, far to often it is easy to rush that part. Also be prepared to use the debug-facilities of matlab, I typically turn on debug-stop after an error:
>> dbstop if error
Then you get a command-line prompt at the line where the error occurred with command-line access to all variables in the function and it is possible to step up in the function call-stack.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Simulink Functions dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!