Changing HDL FIR filter numerator while simulation is running
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
We are working on zynq 706 using MATLAB. we are using HDL optimized FIR filter in simulink and we are trying to change filters numenator . but each time we need to stop the simulation for cahnging numenator . How can we change the parameters while simulations contionue to run
0 commentaires
Réponses (2)
Bharath Venkataraman
le 18 Jan 2022
Modifié(e) : Bharath Venkataraman
le 18 Jan 2022
You can set the property Coefficients Source to input port and feed the coefficients via the input port. This will allow you to change coefficients without having to stop the simulation.
Example on how to do this: https://www.mathworks.com/help/dsp/ug/optimizing-prog-fir-resources.html
0 commentaires
muhammad ahmad
le 31 Jan 2022
2 commentaires
Bharath Venkataraman
le 31 Jan 2022
I think it may be best for you to contact MathWorks support with your specific files to see if we can look further into the problem at hand.
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!