How to connect Raspberry Pi to DAC MCP 4921 using SPI Simulink blocks?
14 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I want to set an output voltage with a RaspberryPi with an DAC MCP4921 using Simulink, in particular using the new block "SPI Register Write" available in the latest Simulink version (without writing C code or Matlab code). In this block is required a Register Address where SPI has to write the value from the slave. Can anyone help me?
1 commentaire
Sylvain
le 16 Fév 2023
Looking at the datasheet, the write command register is not defined.
Can you try the "SPI Master Transfer" block with a terminator for the output?
You should send the a vector of [2x1] uint8 for the upper half and the lower half.
Réponses (1)
Mark McBroom
le 5 Fév 2023
Would you want to use the SPI Read/Write/Master blocks to communicate with this external device, similar to this example that uses SPI to communicate with an external EEPROM device?
https://www.mathworks.com/help/supportpkg/raspberrypi/ref/communicating-with-an-eeprom.html
0 commentaires
Voir également
Catégories
En savoir plus sur Modeling dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!