Using Ld and Lq inductance values for IPMSM
18 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Milos Bozovic
le 28 Avr 2023
Réponse apportée : Raghunath Rachabattuni
le 30 Juin 2023
Hello!
I want to implement FOC for IPMSM. I am using the 'Permanent Magnet Synchronous Machine' model in Simulink.
It asks for armature inductance value, but I only have Ld and Lq values. Can I just put [Ld Lq] in that field?
0 commentaires
Réponse acceptée
Raghunath Rachabattuni
le 30 Juin 2023
Additionally, you may also use the Ld Lq and fluxPM values using the blocks MTPA Control Reference and LUT based PMSM Control Reference blocks too.
Additionally you can refer to the following pages for how to use both the blocks
0 commentaires
Plus de réponses (1)
Supraja
le 8 Mai 2023
Assuming that you want to implement FOC using ipmsm. You can use Ld and Lq I understand that you want to implement IPMSM using FOC.
Here is the documentation link for the same: https://www.mathworks.com/help/sps/ug/power-motordrive-IPMSM-FOC.html?searchHighlight=ipmsm%20foc&s_tid=srchtitle_ipmsm%20foc_1
0 commentaires
Voir également
Catégories
En savoir plus sur Multicore Processor Targets dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!