Community Profile

photo

Raghunath Rachabattuni

Last seen: Today Actif depuis 2022

Statistiques

  • Knowledgeable Level 1
  • First Answer

Afficher les badges

Content Feed

Afficher par

A répondu
Kindly tell me if the code (MTPA) is wrong for calculating MTPA curve
You can use the commandline utilities that are shipped with Motor Control Blockset. Please refer to the following links to explo...

7 mois il y a | 0

A répondu
Challenges with Delta Wound Motor in Torque Control: Seeking Guidance on MTPA Reference Block for reference Id and Iq generation.
Hi Aditya, In addition, check the following link for using delta parameters for a motor plant model. One of the options (the...

7 mois il y a | 0

A répondu
to obtain contour plots
You can use the commandline utilities that are shipped with Motor Control Blockset. Please refer to the following links to explo...

10 mois il y a | 0

A répondu
Using Ld and Lq inductance values for IPMSM
Additionally, you may also use the Ld Lq and fluxPM values using the blocks MTPA Control Reference and LUT based PMSM Control Re...

10 mois il y a | 0

| A accepté

A répondu
about the contour plots
To plot the constant torque contours and also other constraint curves of a PMSM, please refer to the following link. PMSM Cons...

10 mois il y a | 0

A répondu
How to draw MTPA curve on torque contours
To know how to draw the MTPA curves, and also other constraint curves of the PMSM, pls refere to the following link. PMSM Cons...

10 mois il y a | 0

A répondu
To calculate the max speed which can be achieved in field weakening region
A recent update to the Motor Control Blockset introduced few utilities to address these. PMSM Drive Characteristics and Constr...

10 mois il y a | 0

A répondu
can you provide me a file about flux weakening model of PMSM in simulink ?
In addition to the above suggested block, you may also use MTPA Control Reference or LUT based PMSM Control Reference blocks. To...

10 mois il y a | 0

A répondu
Field-Weakening Control (with MTPA) of PMSM
Hi You can refer to the following link to know the the principles behind the MTPA curve of a PMSM, and find how to plot them. ...

10 mois il y a | 0

A répondu
LUT based PMSM control reference ; Vdc input method
To add to the above answer, the 3D LUT option creates a 3D table for both id, iq values that depend on three parameters, namely,...

10 mois il y a | 1

| A accepté

A répondu
Torque control of PMSM motor- Need help
Hi, The torque setpoint can be derived using the PI controller based on the speed setpoint and the speed feddback value. You ma...

plus d'un an il y a | 0