Effacer les filtres
Effacer les filtres

Fixed Wing Manual Control using RC Transmitter/Joystick

11 vues (au cours des 30 derniers jours)
Hasan Khanzada
Hasan Khanzada le 15 Mai 2023
I am trying to Run Fixed Wing Manual Control using RC Transmitter/Joystick Example for PX4 using Logitech Extreme 3D Pro JoyStick. I have callibrated the joy stick and configured Diiferent Switches for Mode Change. But when i run the examle nothing happens when i increase throttle. When throttle is high it does not Arm and give Error and Throttle is high. Additionally mode changes when i press the respective joystick button. Appearently it shows that i have callibrated joystick correctly. Why does not any thing happen on throttle Increase ?
Note: I have Perfromed all the required settings in Q Ground and Matlab and therefore it worked perfectly fine in Autonomous Mission using Qgound and Manual Simulink Mission.
  2 commentaires
Manoj Velmurugan
Manoj Velmurugan le 16 Mai 2023
Is this the example you are using?
Were you able to arm using the joystick (and see the armed status in the top left corner of QGC)?
Hasan Khanzada
Hasan Khanzada le 16 Mai 2023
Yes i am using the Matlab Example and did not make any edit in it. Yes i was able to arm using Joystick and The status is Arm.

Connectez-vous pour commenter.

Réponse acceptée

Debadipto
Debadipto le 6 Fév 2024
The issue you're describing with the throttle not responding and the error message about the throttle being too high during arming could be due to a safety feature in PX4. Apparently, PX4 requires the throttle to be at its lowest position before it will arm to prevent accidental motor engagement.
I would suggest you to refer to the following relevant Github issue:

Plus de réponses (0)

Produits


Version

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by