Effacer les filtres
Effacer les filtres

Automated Green House Temperature Control

6 vues (au cours des 30 derniers jours)
Daniel Mersha
Daniel Mersha le 24 Nov 2011
How to write a program which will read and monitor the green house temperature from a temperature sensor and compare it with the threshold temperature 290C.If the temperature in the green house goes up switch the fan on for cooling and if it goes down switch the heater on for heating
  2 commentaires
Jan
Jan le 24 Nov 2011
Well, I assume the "green" house will get brown very fast near to 290C.
A simple temperature siwtcher should be able to do this without using a program or even Matlab.
bym
bym le 24 Nov 2011
perhaps 290K is more reasonable

Connectez-vous pour commenter.

Réponse acceptée

Walter Roberson
Walter Roberson le 24 Nov 2011
That sounds like a use for a PID Controller, or perhaps just some Fuzzy Logic.
I suspect you would not want the continually switching on and off, where the fan starts, the temperature almost immediately decreases, the fan switches on, the non-longer cooled area warms to a fraction over 290, the fan switches on, the fan switches off, the fan motor burns out...
  2 commentaires
Jan
Jan le 24 Nov 2011
A bi-metal switch circuit breaker with a weak magnet for a hysteresis will solve the problem. Daniel, if you implement this for a real application, be sure to check out: http://www.mathworks.com/matlabcentral/answers/9073-what-is-your-unusual-use-of-matlab
Walter Roberson
Walter Roberson le 25 Nov 2011
Bah, those engineers, always wanting to throw hardware at problems!!
:-)

Connectez-vous pour commenter.

Plus de réponses (1)

Prasad Kalane
Prasad Kalane le 19 Juil 2013
>> I had a code for plotting data from sensor.(tested on LM35,ARM-LPC2148,MATLAB 2010) >> Pls edit in that code as well as in controller program.
% *************************************************************************
s1 = serial('COM4'); %define serial port
s1.BaudRate=9600; %define baud rate
fopen(s1); %open serial port
clear data; % data must be in a Coloumn vector (do this setting from controller by using delay & next %line ) e.g. [1;2;3;6;7;8;9]
for i= 1 :10 %acquisition of 100 points
data(i)=(str2double(fscanf((s1)))); %read sensor
disp(sprintf('Temperature= %3.2f oC' ,data(i)))
end
fclose(s1);
i=(1:10); plot(i,data,'--rs','LineWidth',1,... 'MarkerEdgeColor','k',... 'MarkerFaceColor','m',... 'MarkerSize',5)
xlabel('Time')
ylabel('Temparature(celcious)')
title('Plot of Temparature Vs Time')
% then use codition of If...end

Catégories

En savoir plus sur Data Acquisition Toolbox Supported Hardware dans Help Center et File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by