Simulink Real-Time with RS-232 (receiving data)
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Jeet panchal
le 19 Mar 2019
Modifié(e) : Stefanie Schwarz
le 27 Avr 2023
I would like to model a Simulink project where my data is coming from RS232 (UART to USB) to MATLAB Simulink Real-Time model.
I would like to see the data passed on through my UART on a scope.
I have used baseboard RS232 parameter group is Board setup(com1/none).
Using MATLAB function ( DC = fcn(u)) and passing the u value directly to scope.
I am getting errors while building the project("External mode open protocol connect command failed").
Please find the attachments regarding error and my simulation below.
0 commentaires
Réponse acceptée
Akshay Khadse
le 28 Mar 2019
Modifié(e) : Stefanie Schwarz
le 27 Avr 2023
Please run the following command in the MATLAB Command Window to verify the Simulink Real Time installation for R2020a and earlier:
>> slrttest
Please refer the following documentation page for more information on this command:
Please check if your PCI settings are specified as recommended in the following MATLAB Answers page:
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Target Computer Setup dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!