Installation et configuration

Installation du hardware

Supported ARM Cortex-A Processors for Raspberry Pi Hardware

ARM^® Cortex^®-A processors supported by Raspberry Pi boards.

Set Up Operating System on Raspberry Pi Board

This section shows how to set up an environment for your Raspberry Pi board before you install the support package.

Install Support for Raspberry Pi Hardware

Install support for Raspberry Pi hardware.

Modularize Installation of Third-Party Packages and Libraries for Raspberry Pi Hardware

This section describes the workflow for downloading the core and optional application-based libraries and packages.

Enable Passwordless Sudo on Raspberry Pi Hardware

Run Simulink models on Raspberry Pi without providing a password.

Enable and Configure Raspberry Pi for SPI and CAN Communication Using MCP2515 CAN Controller

This section provides a comprehensive workflow to enable and configure the MCP2515 CAN interface on a Raspberry Pi board.

Setup Virtual CAN Interface

Setup virtual CAN interface before configuring CAN Transmit and CAN Receive blocks.

Enable Secondary I2C Bus of Raspberry Pi Hardware

Use the instructions in this section to enable the secondary I2C bus interface on your Raspberry Pi hardware board.

Enable Secondary SPI Bus of Raspberry Pi Hardware

Use the instructions in this section to enable the secondary SPI bus interface on your Raspberry Pi hardware board.

Paramètres de configuration du réseau

Configurer les paramètres réseau de hardware Raspberry Pi

Configurer les paramètres réseau de votre hardware Raspberry Pi.

Get IP Address of Raspberry Pi Hardware

You can use any of these methods to know the IP address of your Raspberry Pi hardware.

Access Internet When Raspberry Pi Is Directly Connected to Computer Using Ethernet

When Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.

Accéder au système d’exploitation Linux et le configurer

Open Command-Line Session with Raspberry Pi Hardware

Open a serial command-line session with Raspberry Pi hardware.

Access Linux on Raspberry Pi Using Computer Peripherals

Set up Raspberry Pi hardware as a Linux^® desktop or terminal.

Run Linux Shell Commands on Raspberry Pi Hardware

This example shows you how to run Linux® shell commands on your Raspberry Pi® hardware.

Extend Linux Partition on SD Card

Extend Linux partition on the SD card for Raspbian Linux image.

Configurer les paramètres dans la boîte de dialogue Paramètres de configuration

Model Configuration Simulink Support Package for Raspberry Pi Hardware

This section describes about the model configuration parameters.

Additional Capabilities with Simulink Coder and Embedded Coder

Include additional capabilities for code generation.

Configurer Simulink Online

Connect to Raspberry Pi Hardware Board in Simulink Online

Configure, connect to, and control Raspberry Pi hardware in Simulink Online™.

Security Considerations for Raspberry Pi in Simulink Online

Take steps to secure your Raspberry Pi in Simulink Online.