Main Content

Installation et configuration

Installer le support hardware, mettre à jour le micrologiciel, configurer la connexion hardware

  • L'écran de configuration du hardware fournit des instructions étape par étape pour installer et configurer le Support Package Simulink® pour hardware Raspberry Pi®. Pour plus d’informations sur le processus d’installation, voir Installer le Support Package Simulink pour Raspberry Pi.

  • Apprenez à établir la communication entre l'ordinateur hôte et votre hardware Raspberry Pi.

Fonctions

raspberrypiGet host name, user name, password, and build directory

Installation du hardware

Install Support for Raspberry Pi Hardware

Install support for Raspberry Pi hardware.

Modularize Installation of Third-Party Packages and Libraries for Raspberry Pi Hardware

This section describes the workflow for downloading the core and optional application-based libraries and packages for the Simulink Support Package for Raspberry Pi Hardware.

Enable Passwordless Sudo on Raspberry Pi Hardware

Run Simulink models on Raspberry Pi without providing a password.

Setup Virtual CAN Interface

Setup virtual CAN interface before configuring CAN Transmit and CAN Receive blocks.

Paramètres de configuration du réseau

Configure Network Settings of Raspberry Pi Hardware

Configure the network settings of your Raspberry Pi hardware.

Get IP Address of Raspberry Pi Hardware

You can use any of these methods to know the IP address of your Raspberry Pi hardware.

Access Internet When Raspberry Pi Is Directly Connected to Computer Using Ethernet

When Raspberry Pi hardware is directly connected to a computer using an Ethernet cable, perform these steps to access the Internet from the hardware.

Accéder au système d’exploitation Linux et le configurer

Open Command-Line Session with Raspberry Pi Hardware

Open a serial command-line session with Raspberry Pi hardware.

Access Linux on Raspberry Pi Using Computer Peripherals

Set up Raspberry Pi hardware as a Linux® desktop or terminal.

Run Linux Shell Commands on Raspberry Pi Hardware

This example shows you how to run Linux® shell commands on your Raspberry Pi® hardware.

Extend Linux Partition on SD Card

Extend Linux partition on the SD card for Raspbian Linux image.

Configurer les paramètres dans la boîte de dialogue Paramètres de configuration

Model Configuration Simulink Support Package for Raspberry Pi Hardware

This section describes about the model configuration parameters.

Additional Capabilities with Simulink Coder and Embedded Coder

Include additional capabilities for code generation.

Configurer Simulink Online

Connect to Raspberry Pi Hardware Board in Simulink Online

Configure, connect to, and control Raspberry Pi hardware in Simulink Online™.

Security Considerations for Raspberry Pi in Simulink Online

Take steps to secure your Raspberry Pi in Simulink Online.