How to set initial condition y(1)=1 in solving ODE using Simulink?

22 vues (au cours des 30 derniers jours)
Yugal Maheshwari
Yugal Maheshwari le 23 Déc 2018
Commenté : Yugal Maheshwari le 30 Déc 2018
Can anyone guide me how can I set initial conditions for ODE in Simulink. It is easy to set Y(0)=0 or 1 in integerator. How to set Y(1)=1 in integrator.
I wanna solve dy/dt= (2/t) y , where y(1)=1 as initial condtions in Simulink.
  2 commentaires
Aquatris
Aquatris le 26 Déc 2018
If y(1) = 1 is your initial condition, it means your starting "time" is 1. Why not just set the integrator initial to 1 and offsett the time value whereever it appears in your equations?
Yugal Maheshwari
Yugal Maheshwari le 30 Déc 2018
Yes, it works. Thanks!

Connectez-vous pour commenter.

Réponses (1)

Akshay Khadse
Akshay Khadse le 28 Déc 2018
As Aquatris mentioned, the Start Time for simulation should be specified as 1 from the Configuration Parameters.
Then, you can specify the initial condition using any of the following methods:
1) Specify the Initial condition in the Integrator block parameters as 1. OR
2) Use Simulink.BlockDiagram.getInitialState as follows
x0 = Simulink.BlockDiagram.getInitialState(gcs);
x0{1}.Values.Data = 1;
Please refer the following documentation page to know more about the Simulink.BlockDiagram.getInitialState

Tags

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by