Configuration de réglage des modèles Simulink

Configuration des modèles Simulink^® pour le réglage en ligne de commande

Pour régler un modèle Simulink en ligne de commande, utilisez l’interface slTuner pour configurer le modèle pour le réglage, spécifier les blocs à régler et indiquer les points d’analyse. L’interface slTuner stocke une approximation linéaire du modèle Simulink et les autres informations nécessaires au réglage du système. Pour un exemple, voir Create and Configure slTuner Interface to Simulink Model. (Le réglage des modèles Simulink nécessite le software Simulink Control Design™.)

Fonctions

développer tout

Création d’une interface slTuner

`slTuner`	Interface for control system tuning of Simulink models
`slTunerOptions`	Set `slTuner` interface options

Modification d’une interface slTuner

`addBlock`	Add block to list of tuned blocks for `slTuner` interface
`addOpening`	Add signal to list of openings for `slLinearizer` or `slTuner` interface
`addPoint`	Add signal to list of analysis points for `slLinearizer` or `slTuner` interface
`refresh`	Resynchronize `slLinearizer` or `slTuner` interface with current model state
`removeAllOpenings`	Remove all openings from list of permanent openings in `slLinearizer` or `slTuner` interface
`removeAllPoints`	Remove all points from list of analysis points in `slLinearizer` or `slTuner` interface
`removeBlock`	Remove block from list of tuned blocks in `slTuner` interface
`removeOpening`	Remove opening from list of permanent loop openings in `slLinearizer` or `slTuner` interface
`removePoint`	Remove point from list of analysis points in `slLinearizer` or `slTuner` interface
`setBlockParam`	Set parameterization of tuned block in `slTuner` interface
`setBlockRateConversion`	Set rate conversion settings for tuned block in `slTuner` interface
`setBlockValue`	Set value of tuned block parameterization in `slTuner` interface
`writeBlockValue`	Update block values in Simulink model
`writeLookupTableData`	Update portion of tuned lookup table

Requête sur l’interface slTuner

`getBlockParam`	Get parameterization of tuned block in `slTuner` interface
`getBlockRateConversion`	Get rate conversion settings for tuned block in `slTuner` interface
`getBlockValue`	Get current value of tuned block parameterization in `slTuner` interface
`getOpenings`	Get list of openings for `slLinearizer` or `slTuner` interface
`getPoints`	Get list of analysis points for `slLinearizer` or `slTuner` interface
`showTunable`	Show value of parameterizations of tunable blocks of `slTuner` interface

Rubriques

Create and Configure slTuner Interface to Simulink Model
Use slTuner to create an interface to a Simulink model for command-line control system tuning and analysis.
Tune Control Systems in Simulink
At the command line, use systune or looptune to automatically tune control systems modeled in Simulink.
Mark Signals of Interest for Control System Analysis and Design
Analysis points allow you to access to internal signals, perform open-loop analysis, or specify requirements for controller tuning in systems modeled in either MATLAB^® or Simulink.
How Tuned Simulink Blocks Are Parameterized
Both Control System Tuner and the slTuner interface automatically assign predefined parameterizations to certain Simulink blocks.